Storing Prests

Once you have changed settings on your Keystation Pro 88, you will want to save these changes to memory. Please note
that the factory presets are stored in ROM within the keyboard and can therefore be restored at any time.

To store a preset:

1. Press the function button STORE.
2. Using they numerical keypad, enter in the preset memory number that you wish to store the preset to.

If you want the Keystation Pro 88 to revert back to the factory defaults, simply hold down the “+/-” buttons while switching the keyboard on.

Recalling Presets

The Keystation Pro 88 has 10 factory-programmed presets. 

To recall a preset:

1. Press the function key labeled RECALL.
2. Type in the number of the preset you want using the numerical keypad.

The following is a list of the presets contained in the 10 memory locations.

Saving and Recalling Individual Groups of Controllers

The controllers of the Keystation Pro 88 are divided into three Groups.

Group A:

• Pitch Bend Wheel
• Modulation Wheel
• Transport buttons (5 buttons above the wheels)
• Sustain Pedals 1 and 2 (pedals not included)
• Expression pedal (pedal not included)
• Settings for all Zones

Group B:

• 24 Rotary knobs
• 8 buttons below the rotary knobs

Group C:

• 9 Faders
• 9 buttons below the faders

To clarify the group a controller belongs to, each assignable controller has been labeled with a letter and a number. The letter represents the controller’s group designation.  When you press STORE or RECALL, you will see the LEDs above the ZONE/GROUP buttons flashing. Group mode is automatically selected, and the flashing LEDs represent the Groups that the MEMORY STORE/RECALL will apply to.  When you press STORE, all groups are selected automatically. If you press RECALL, the group settings for the last recall are remembered and selected accordingly.

Example 1: Storing Only the Faders (to preset 3):

1. Press the STORE button.
2. Press the “Group A” and “Group B” buttons. Only GROUP should be flashing on the LCD display.
3. Enter “03” using the numerical keypad or +/- buttons.
   
    

Example 2: Recalling only the Zone Settings (of Preset 2):

1. Press the RECALL button.
2. Ensure Groups B and C are not selected. By pressing the group buttons for groups B and C, the LCD should not display them.
3. Ensure Group A is selected by pressing the “Group A” button until Group A is displayed in the LCD.
4. Enter “02” using the numeric keypad or the +/- buttons.